How To Improve The Grasping Power And Anti-wear Of The Grab Bucket

Jul 10, 2024

Leave a message

Customers have certain requirements for height when using the grab. The product itself is simple, does not need an external power supply, and will not fail when used. If the height is sufficient when used, it is generally recommended to use a remote control grab.
When the grab is continuously working, the temperature of the hydraulic oil will not rise. The main reason is that during the grab, the goods sometimes suffocate. In this case, if the quantitative pump is used, because the displacement of the oil pump is constant, if the cargo is suffocated, the hydraulic oil in the equipment will overflow through the relief valve.
The result of long-term overflow is that the oil temperature rises faster, the oil temperature will be higher and higher, but some temperatures are too high will lead to the rapid aging of the seal and equipment tubing, when the oil temperature is relatively high, the grab is unstable, if the bud can not be maintained, the grab will fall off.
The working pressure set by the grab system is greater than that set by the pump system, so it is necessary to improve the grab force of the grab system. If the grab motor is in a state of load release when it starts, the whole motor will start no-load, so that the motor starting current is less than the motor starting current, the components in the equipment should have a certain protective effect, and a quantitative pump can be used.
The frequent failure of the grab in the working process is the wear of the abrasive, which can be analyzed according to the tubing data. You can find that if the grab fails, it is mainly the loss of functional performance caused by wear. It can be seen that improving the wear resistance of the grab is very important, and it is also an important way to improve the service life of the grab.