The maintenance of marine telescopic deck cranes shall be carried out around four core modules: the hydraulic system, mechanical structure, electrical control system, and safety devices. Meanwhile, in combination with the characteristics of the high-salt-spray and high-humidity environment of marine offshore operations, special attention shall be paid to anti-corrosion and regular inspection.
The specific precautions are as follows:
Hydraulic System Maintenance
A: Oil Management
Regularly check the crane's oil level, cleanliness, and viscosity of hydraulic oil, and replace the hydraulic oil in accordance with the requirements of the marine telescopic deck crane equipment manual (usually every 2000 operating hours or 1 year). During replacement, the oil tank and filters shall be cleaned simultaneously to prevent impurities from entering the system.
B: Seal Inspection
Focus on inspecting the crane's seals of telescopic boom cylinders, slewing motors, winch hydraulic components, etc. If oil leakage, aging, or cracking is found, the seals must be replaced immediately. The seals shall be made of seawater corrosion-resistant fluororubber to adapt to the offshore operating environment.
C: Pipeline Fastening
Regularly check the joints, flanges, and pipe clamps of hydraulic pipelines to ensure there is no looseness, deformation, or wear. Install protective sleeves on exposed pipelines to prevent pipeline rupture caused by wave impact and hull vibration.
Mechanical Structure Maintenance
A: Telescopic Boom & Structural Components
Inspect the welds, pins, and connecting plates of the telescopic boom for cracks, deformation, or corrosion before each operation. Apply special-purpose lubricating grease to the sliding surfaces of the telescopic boom at regular intervals to ensure smooth telescopic movement of the marine telescopic deck crane. Promptly remove rust from corroded areas of structural components, and apply anti-rust primer and topcoat.
B: Slewing & Hoisting Mechanisms
Check the tooth surface wear of the slewing bearing, and regularly fill it with gear oil to ensure there is no abnormal noise or jamming during slewing. Conduct a comprehensive inspection of the steel wire ropes of the hoisting winch, focusing on the degree of wire breakage, wear, and corrosion. If the number of broken wires exceeds the standard or the diameter wear amount is more than 10%, the wire ropes must be replaced immediately. The steel wire ropes shall be regularly coated with anti-rust lubricating grease to avoid seawater corrosion.
C: Pins & Bearings
Regularly lubricate all connecting pins and pulley bearings (every 500 operating hours) with water-resistant lubricating grease. Check whether the split pins and circlips of the pins are intact to prevent safety accidents caused by pin detachment.
Electrical Control System Maintenance
A: Circuit & Component Protection
Given the high humidity and heavy salt spray on the ship deck, it is necessary to regularly inspect the sealing performance of the marine telescopic deck crane's electrical control cabinet, ensure the integrity of the cabinet door sealing strips, and prevent moisture and salt spray from intruding. Conduct insulation treatment on circuit joints, check cables for aging or damage, and replace damaged cables promptly.
B: Sensors & Control Units
Check the sensitivity of safety sensors such as load limiters, luffing limiters, and height limiters, and perform regular calibration. Clean the surface dust of control buttons, touch screens, and PLC modules to ensure accurate command transmission.
C: Motor Maintenance
Check the insulation resistance of hoisting motors and slewing motors to ensure compliance with safety standards. Keep the motor housing clean and the heat dissipation vents unobstructed to prevent motor burnout caused by overload or poor heat dissipation.
Safety Device Maintenance
A: Limiting & Protection Devices
Test the effectiveness of load limiters, moment limiters, and emergency stop buttons weekly to ensure the marine telescopic boom deck crane can automatically alarm and cut off power in case of overload. Check the functions of windproof anchoring devices and rail clamps, and confirm the anchoring is firm before severe weather.
B: Hooks & Pulleys
Check the hooks for deformation, cracks, and wear. Hooks with more than 10% wear at the dangerous section shall be scrapped. If pulley grooves are excessively worn or cracked, replace them in a timely manner to prevent steel wire ropes from slipping out of the grooves.
C: Brake Systems
Regularly inspect the brakes of the hoisting winch and slewing mechanism, adjust the brake clearance to ensure sensitive and reliable braking. Check the thickness of brake pads and replace them immediately when the wear amount exceeds the standard.
Environment Adaptability Maintenance
A: Anti-corrosion Treatment
Remove rust and touch up paint on exposed metal parts of the marine telescopic deck crane monthly, focusing on the base, telescopic boom, handrails, and other components. Use hot-dip galvanized or stainless steel fasteners such as bolts and nuts, and apply anti-rust agent regularly.
B: Cleaning Management
Timely clean seawater, oil stains, and debris on the equipment surface after operation to prevent corrosion caused by salt residue. Regularly clean the marine telescopic deck crane with a high-pressure water gun, but avoid electrical control cabinets, motors, and other components with high waterproof requirements.
Documentation & Cycle Management
- Establish a maintenance record book, and record the time, content, model of replaced parts, and operators in detail for each maintenance activity.
- Strictly follow the cycle requirements in the marine telescopic deck crane equipment manual to distinguish between daily inspections (per shift), regular maintenance (monthly/quarterly), and annual overhauls. Avoid neglecting maintenance due to busy offshore operations.
- Conduct non-destructive testing (such as ultrasonic testing and magnetic particle testing) in conjunction with professional institutions during annual overhauls to detect hidden internal cracks in structural components.
👍 www.yfm-crane.com
👍 +86 15818704927
👍 anne@yfm-crane.com/info@yfm-crane.com
👍 https://www.yfm-crane.com/contact-us
#marine deck crane#telescopic boom marine crane#telescopic boom deck crane#telescopic marine crane#telescopic deck crane#





